濟南油煙凈化器使用一段時間后會進行清洗，但是很多用戶發現清洗完成后，油煙凈化器的凈化效果變差了，而油煙凈化器的凈化效果是以下三點造成的：
Jinan oil fume purifier will be cleaned after being used for a period of time, but many users find that after cleaning, the purification effect of the oil fume purifier becomes worse, and the purification effect of the oil fume purifier is caused by the following three points:
自身質量問題
Own quality problems
客戶使用質量差的凈化器時，油煙凈化器低壓區的板厚很薄。清洗后腐蝕非常嚴重，導致油煙凈化器的電導率、電離能力和吸附能力急劇下降。有一些便宜的。凈化器的電出彩板甚至是用鍍鋅板做的，清洗后直接報廢，凈化效果很差。
When the customer uses the purifier with poor quality, the plate thickness in the low-pressure area of the fume purifier is very thin. After cleaning, the corrosion is very serious, resulting in a sharp decline in the conductivity, ionization capacity and adsorption capacity of the fume purifier. There are some cheap ones. The electrode plate of the purifier is even made of galvanized plate, which is directly discarded after cleaning, and the purification effect is very poor.
清潔方法
Cleaning method
很多用戶在清洗時，清洗方法不正確，導致清洗不有效，清洗不有效也會影響凈化效果。那么如何判斷它是否干凈呢？事實上，這很簡單。清洗后，檢查電場片是否白亮，上面沒有油脂。測試時，建議通過光度法檢測。如果電出彩板上的油脂沒有清洗干凈，會影響電出彩板的放電和吸附。
When many users are cleaning, the cleaning method is incorrect, resulting in incomplete cleaning. Incomplete cleaning will also affect the purification effect. So how to judge whether it is clean? In fact, it's very simple. After cleaning, check whether the electric field sheet is white and bright, and there is no grease on it. During the test, it must be detected by photometry. If the grease on the electrode plate is not cleaned, the discharge and adsorption of the electrode plate will be affected.
其實很多廠家都會給用戶推薦一個外電場來判斷電場是否干凈或者有沒有異物。當然，這種方法對電出彩片電場密集的情況有效，可以從點火位置判斷是否正常工作，但不適用于電場片間距較寬的電場，它對電場非常敏感。低，只有一點點異物是很難點燃的，確實會影響傳導。
In fact, many manufacturers will recommend an external electric field to users to judge whether the electric field is clean or whether there are foreign matters. Of course, this method is effective in the case of dense electric fields of electrode sheets. It can judge whether it works normally from the ignition position, but it is not applicable to the electric field with wide spacing of electric field sheets. It is very sensitive to the electric field. Low, only a little foreign matter is difficult to ignite, which will indeed affect the conduction.
如何安裝
How to install
事實上，很多用戶對
濟南油煙凈化器的了解并不多。油煙凈化器清洗后，連上面的撞針都漏了，或者安裝不正確，導致油煙釋放裝置無法工作，那么凈化效果如何呢？另外提醒大家，安裝油煙凈化器的時候一定要選擇大，不要因為便宜就在網上買。否則，如果出現問題，您甚至可能無法享受基本服務。
In fact, many users do not know much about Jinan lampblack purifier. After the oil fume purifier is cleaned, even the striker on it leaks, or the installation is incorrect, resulting in the failure of the oil fume release device. How about the purification effect? In addition, I would like to remind you that you must choose a big brand when installing the fume purifier, and do not buy it online because it is cheap. Otherwise, if something goes wrong, you may not even be able to enjoy basic services.
要注意油煙凈化器的電場在清洗結束后，不要著急地安裝回去，一定要對其進行檢查，看看油煙凈化器的電場是否在清洗的過程中，有沒有出現變形，檢查拆下來的電場里面有沒有雜物，另外就是要時刻注意不要清洗抹布屑、清洗用的鋼絲球留在上面。
It should be noted that after the cleaning of the electric field of the oil fume purifier, do not rush to install it back. Be sure to check it to see whether the electric field of the oil fume purifier is deformed during the cleaning process. Check whether there are sundries in the removed electric field. In addition, be careful not to leave cleaning rags and cleaning steel balls on it at all times.
The above is the relevant content about the problem shared for you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website http://www.zypolishing.com 。
上一篇：如何區分排煙管道和通風管道
下一篇：通風管道建議是定好日期進行一次多維度清理！
