油煙凈化器主要用于廚房低空排放油煙的凈化治理。當油煙凈化器使用一段時間后，由于內部積滿了油污，凈化處理效果明顯下降。因此，在設備試用期間，應及時對油煙凈化器進行維護清洗。下面山東通風管道加工的小編為您講解油煙凈化器日常養(yǎng)護的相關信息。
    The oil fume purifier is mainly used for purifying and purifying the cooking fumes emitted from the kitchen at low altitude. When the oil fume purifier was used for a period of time, the purification effect decreased obviously because of the oil contamination inside. Therefore, during the trial period, the oil fume purifier should be cleaned and cleaned in time.
    1、清洗的重要性 the importance of cleaning
    確保凈化器的凈化效率；油過多會引起火災隱患。
    Ensure the purifier's efficiency; excessive oil will cause fire hazards.
    2、清洗周期 Cleaning cycle
    凈化器使用兩至三個月后需要清洗，在廚房油煙較多的情況下應縮短清洗周期，以保證凈化器的處理效果。
    The purifier should be cleaned after two to three months, and the cleaning cycle should be shortened in the case of more fumes in the kitchen, so as to ensure the treatment effect of the purifier.


    3、清洗劑 Cleaning agent
    將洗潔精按3%的比例倒入盛有40-50攝氏度的熱水清洗槽內攪拌，使之充分溶解。工業(yè)燒堿和水按1;15的比例配置所需要清洗劑。油煙凈化器專用化學清洗劑。
    Pour the detergent into 3% of the hot water cleaning tank with 40-50 degrees Celsius and make it fully dissolved. Industrial caustic soda and water should be allocated 1 to 15 of the required cleaning agent. Special chemical cleaning agent for oil fume purifier.
    4、清洗方法 Cleaning method
    切斷電源，打開檢修門；將預處理網拉出；放入清洗槽中浸泡十分鐘，輕輕將網上油污清洗干凈，并用清水有效沖洗干凈；將清洗后預處理網自然風干；將干燥的預處理網按原位置放回油煙凈化器。
    Cut off the power supply, open the maintenance door, pull the preconditioning net out, soak in the cleaning tank for ten minutes, gently clean the oil stains on the net, rinse thoroughly with clean water, clean the net naturally after the cleaning, and put the dry pretreatment net back to the oil fume purifier according to the original position.
    切斷電源，打開檢修門，取出電場，用清潔片放在電出彩板中間，貼著電出彩板由上向下移動，只需將電出彩板上大部分油污清理掉即可，一次清理不干凈，可以多次清理；清理干凈刮下的油污，用清水洗干凈；清洗過的電場自然風干；將干燥的電場按原位置放回凈化器，關上檢修門便可以重新工作。
    Cut off the power supply, open the repair door, take out the electric field, use the clean sheet in the middle of the electrode plate, move the electrode plate up and down, only need to clean up most of the oil pollution on the electrode plate, one time clean up not clean, can clean up many times; clean clean shaved oil, wash clean with clear water; clean the natural wind of electric field. Dry; put the dry electric field back to the purifier according to the original position, and then turn on the door to rework.
    如想詳細咨詢相關信息，歡迎訪問山東通風管道加工官網http://www.zypolishing.com/。

上一篇：通風系統(tǒng)安裝注意事項
下一篇：風機葉輪不平衡是什么原因？